Optical Cabel Suspension Clamp For ADSS , Overhead Line Fittings
*Optical cabel suspension clamp Double Suspension Sets for
ADSS High intensity;
*Well corrosion resistance;
preformed wire,rubber insert ,casting aluminium suspension splint.
1, supporting,make ADSS cable hang on the pole and tower.
2,suggested to use within the span no more than 150 miles and
intersection angle no more than 15°.
The FIBERLIGN Dielectric Suspension is specifically designed for
installation on ADSS cables and is different than FIBERLIGN
Suspension for OPGW. Due to the relatively fragile nature of the
plastic jackets and nonmetallic strength members of ADSS, special
care and features are incorporated into the design. FIBERLIGN
Dielectric Suspension for ADSS is intended for long spans where
suspension is desired regardless of span, where very high
unbalanced longitudinal holding strengths are desired or where very
high veritcal loads are expected. Call for ordering instructions.
Optical fiber cable fitting is a kind of line products used for
installing support and protection of OPGW & ADSS cable.
1. OPGW Suspension set
2. ADSS Suspension set
Suspension clamp widely used in overhead lines fittings and
substations,connecting with overhead ground wire,insulator,on the
equipment .It incluses a series of type, such as the type with
clevis,abrasion proof type, corona proof type,hang up or down
envelope type.the material can be Malleable cast-iron or aluminum
As the suspension clamps are used to AAC and ACSR,the conductor may
be wound by aluminium taps or preformed armour rods for protecting
these taps or rods are included in the diameter of suitable